Volkswagen Golf Mk5 2.0 TDI 140bhp — Starter Motor Solenoid / Brush Wear
The starter motor wears out internally. This is particularly common on vehicles equipped with Stop/Start systems.
Severity
SevereDIY Difficulty
Moderate
Est. Cost
£150–£350
OBD Codes
None
Symptoms
- A single loud 'click' when turning the key, but engine doesn't crank
- Engine cranks very slowly despite a fully charged battery
- Whirring or grinding noise after the engine starts
Root Cause
The carbon brushes inside the motor wear down to the copper wiring, or the contacts inside the solenoid burn out from repeated arcing.
How To Fix
- Confirm battery voltage is strong under load (to rule out a dead battery).
- Replace the starter motor unit.
- Ensure main earth straps from engine block to chassis are clean and tight.
- Cost: £150-350
Estimated Repair Costs
| Repair Option | Est. Cost (GBP) |
|---|---|
| DIY (parts only) | £60–£140 |
| Independent Garage | £150–£350 |
| Main Dealership | £240–£560 |
Other Faults on This Variant
High Pressure Fuel Pump Cam Follower Wear
CriticalThe PD (pumpe-düse) 2.0 TDI uses a mechanical cam follower to drive the high-pressure fuel pump. This follower wears rapidly and if not replaced destroys the camshaft — a £2,500 repair for a £15 part.
Dual Mass Flywheel Failure
SevereDMF failure on the Golf Mk5 2.0 TDI is a rite of passage for high-mileage cars. The flywheel absorbs diesel engine vibrations but wears out — often needing clutch replacement at the same time.
Gearbox Dogbone Mount Bush Failure
MinorThe lower engine pendulum mount (often called the dogbone mount) bushes perish, causing excessive engine movement, clunking, and sloppy gear changes.
Disclaimer: Repair cost estimates are indicative and based on community data. Always get a quote from a qualified mechanic before proceeding with any repair.