Land Rover Freelander 2 2.2 SD4 190bhp — Starter Motor Solenoid / Brush Wear
The starter motor wears out internally. This is particularly common on vehicles equipped with Stop/Start systems.
Severity
SevereDIY Difficulty
Moderate
Est. Cost
£150–£350
OBD Codes
None
Symptoms
- A single loud 'click' when turning the key, but engine doesn't crank
- Engine cranks very slowly despite a fully charged battery
- Whirring or grinding noise after the engine starts
Root Cause
The carbon brushes inside the motor wear down to the copper wiring, or the contacts inside the solenoid burn out from repeated arcing.
How To Fix
- Confirm battery voltage is strong under load (to rule out a dead battery).
- Replace the starter motor unit.
- Ensure main earth straps from engine block to chassis are clean and tight.
- Cost: £150-350
Estimated Repair Costs
| Repair Option | Est. Cost (GBP) |
|---|---|
| DIY (parts only) | £60–£140 |
| Independent Garage | £150–£350 |
| Main Dealership | £240–£560 |
Other Faults on This Variant
Timing Belt Failure and Water Pump Failure
CriticalThe 2.2 SD4 Freelander 2 has a timing belt with a 120,000-mile interval but the water pump is driven by the same belt — and water pump failure destroys the belt. This is a common and expensive failure.
Throttle Body / Anti-Shudder Valve Strip
ModerateThe electronic throttle body (anti-shudder valve) strips its internal plastic gears, causing an unpleasant engine shutdown and a warning light.
Rear Differential Pinion Bearing Failure
CriticalA howling or droning noise from the rear of the car is almost always the rear differential pinion bearing failing. This is incredibly common on all Freelander 2s.
Disclaimer: Repair cost estimates are indicative and based on community data. Always get a quote from a qualified mechanic before proceeding with any repair.