Nissan Qashqai J10 1.5 dCi 106bhp — Suspension Coil Spring Snapping
A very common MOT failure in the UK. Suspension coil springs corrode and snap, usually near the bottom pigtail.
Severity
SevereDIY Difficulty
Hard
Est. Cost
£150–£300
OBD Codes
None
Suspension
Typical layout and location for the Suspension assembly.
Symptoms
- Loud 'twang' or bang when turning the steering wheel at low speeds
- Car sits noticeably lower on one side
- Grating noise over bumps
Root Cause
The protective coating on the steel spring chips from stone impacts. Salt water corrodes the exposed steel, weakening the spring until it fractures under load.
How To Fix
- Visually inspect all four springs for fractures at the very bottom coil.
- Always replace coil springs in pairs across an axle to maintain handling balance.
- Cost: £150-300 per pair at an independent garage.
Estimated Repair Costs
| Repair Option | Est. Cost (GBP) |
|---|---|
| DIY (parts only) | £60–£120 |
| Independent Garage | £150–£300 |
| Main Dealership | £240–£480 |
Other Faults on This Variant
Timing Chain Failure (K9K Engine)
SevereThe Renault/Nissan K9K 1.5 dCi engine in the Qashqai J10 is known for timing chain wear. Unlike a timing belt, there is no scheduled replacement — but chains stretch and tensioners fail.
DPF Blockage and Sensor Failure
ModerateDPF issues on the J10 Qashqai are common because many are used as school-run and short-trip vehicles — exactly the wrong driving profile for a diesel with a DPF.
Steering Column Clicking / Rack Failure
ModerateA clicking or clunking noise when turning the steering wheel at low speeds is extremely common. It usually stems from the steering column universal joint or the rack itself.
Disclaimer: Repair cost estimates are indicative and based on community data. Always get a quote from a qualified mechanic before proceeding with any repair.